Looking for help on my parts list

[SixPointTwo]

So did you guys take the whole harness out of the donor truck? Or just the engine harness? So far all I've pulled is the engine harness interior harness etc. Is all still in the donor truck.

You should only need the engine harness

 

[90W7]

Yep just the engine harness and the segments that run to your b1 and b2 o2 sensors + transmission. You dont need anything from inside Exept the data link connector.

If its drive by wire obviousley you need the pedal assy and the tac module.

You must be registered for see images attach

this is what I started with.

Sent from my throttle body injected galaxy note3

 

[thz71]

Ok cool got all that just didn't Wana pull the entire interior out too bad lol

 

[K30burb]

looks like you are getting there.

 

[jmac1994]

hate to dig up an old thread. but what clutch are you using? the stock 88-98 v8 clutch or clutch for 06 4.8l

 

[95SUBURBANLM7]

I dont know if you want the AN look, if you do skip this.

I was going to use the AN fittings, but I decided to go ahead and use the GMT400's stock fuel lines and just replace the hose with higher pressure hose, crimp fittings, and the LS quick disconnect ends. A lot cheaper and it looks stock. Just make sure you mark the rubber hose ends with each other. Otherwise its a ***** to realign them.