blue_92_sierra
Aftermath
While my trucks been at my buddy's shop getting bodied, I've finally had some time to start cutting up my bed floor. Was planning to do a simple cut out and raise of a factory floor, however, plans changed as the floor I was planning to use had a small twist in it that you could only see in a certain lighting. Couldn't find another nice factory bed floor in good condition so I decided to do build my own floor out of 1x1 and 2x1 square and rectangular tubing. Will be using 14ga sheet metal on the top for added strength and having the floor flow into the lip 8 3/4" down from the top of the bed rails. In totally it's a 10 7/8" raise which will give lots of room to remount my air management under the floor. Here is what I've got done so far.. Once I brace the front with 2x1 I will be able to cut the front section out.
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach