Discussion in 'Engine Performance + Maintenance' started by Curt, Sep 25, 2017.
The pulley will be flush with the pump shaft.
You need to run a bottoming tap through there.
Ah alright, I'll have to pick up a tap and die set then. Thanks
No offense to deathtrap but I won't clean out a hole with a tap because it is designed to remove material by cutting. Instead I make a thread chaser by using an old bolt and cutting a groove across the threads (up and down).
Even better! Helps keep some money in my pocket haha. Thanks for the link, I bookmarked it
That works to.
Separate names with a comma.