Search results

  1. 98slv

    Anybody remove the chrome trim panels on their truck?

    Be sure to use a generous amount of heat, when I took mine off I got tired of pulling them off and went a little too fast. The paint came off with the strips on my cab corners. I think If I would have used more heat I would have been better off. The 3m wheel in a drill is the only way to go to...
  2. 98slv

    Smoking crack

    Yea that truck should be 6-7k max for that. Its probably a Maco paint job. lol
  3. 98slv

    Budget SAS swap questions

    Oh my bad, I didn't pay any attention to the spring widths. I just remembered they offered 2wd to 4wd SAS brackets.
  4. 98slv

    Budget SAS swap questions

    Off Road Unlimited brackets, ff14 bolt rear, a super duty D60 front axle, and 52 inch front leaf springs. That'll give you the option of using a factory 2500 4wd transfer case and a factory rear driveshaft. http://www.offroadunlimited.com/orustore/pc/viewCategories.asp?idCategory=18
  5. 98slv

    ditching lift blocks for just a spring lift?

    My RCSB has a 6inch rough country lift, with the 4.5inch blocks I was replacing u joints all the time (every 4-6 months.) Once I did a shackle flip kit, ORD is where I got mine, it changed my pinion angle back to stock and I haven't had an issue since. Ditch the blocks and stupidly long u-bolts...
  6. 98slv

    Rebuilding my L31, need some opinions on mild upgrades.

    Sub'd interested in that distributor/coil as well.
  7. 98slv

    What did Santa bring you for your OBS

    I bought all new bearings for my HPD60, I was going to order my SAS brackets, but it looks like I need to have my transmission rebuilt instead.
  8. 98slv

    LED light bar mounting

    Not sure how you're going to put a 52inch stright bar in your curved front bumper, best bet is to not put it on at all. Or put it on your roof like every other guy.
  9. 98slv

    Offset/wider stance

    Yeah you'll need a 20x14 or 22x14 to get that much offset. Otherwise you'll need four 2 inch spacers (on each side to get anywhere close to that stance. Everyone has their own thoughts about spacers, I'm running 2 inch spacers of each corner on my half ton. Use to drive it everyday but i was...
  10. 98slv

    ROLLER ROCKERS & PUSH RODS ADVICE????

    running 1.6:1 high ratio Scorpion narrow tip aluminum roller rockers with factory springs and cam. Ran good for 2 or 3 years but I think with 203k on factory springs they are getting weak. Between the rockers, underdrive crank pulley and my superchips handheld it runs pretty good. 1036BL is the...
  11. 98slv

    Where to buy tranny online.

    Monster wasn't googled. I've never used them but would consider them.
  12. 98slv

    Where to buy tranny online.

    monstertransmission.com
  13. 98slv

    Can't find the source of this coolant leak

    Those spring style clamps are junk. You need to get a worm clamp at your local parts store. It will be adjustable so you can tighten it down, just tell them which hose it is and they'll get you the right size. When you put them on wash it up and watch for any leaks.
  14. 98slv

    1998 scsb Z71 48,000 miles

    I'll give them 8k
  15. 98slv

    To SAS or not to SAS

    If you go with the longer 52inch springs it should all ride fairly well. In the long run a think it'll be cheaper to do an SAS. I'm planning my own with my 98. Fabworx has a low boy kit that includes springs and steering pieces...
  16. 98slv

    Identify what I don't need, smog delete.

    The circular deal in the corner with the two black hoses running to it is an air pump. Unplug it, then cap off the hole into the manifold should be all you need to do, your tuner should be able to do the rest. The rectangular box usually indicates it is a 1998 (everything older had round evap...
  17. 98slv

    Egr delete

    All you need is a pipe plug and stick it in the intake. Done.
  18. 98slv

    1997 Chevrolet Tahoe 64K Original Miles 7"Lift

    I'd own that if it were closer too.
  19. 98slv

    Rally strips

    Well I've tried posting a picture, but for whatever reason a picture of my front bumper keeps showing up. Lol
  20. 98slv

    Rally strips

    There's someone else on here with a white truck and blue stripes, let me see if i can find you a picture. O and i think it'll only look good without the banner as well.
  21. 98slv

    New kid from Missouri

    Hey I live in pittsburg, you should plan on going to Hellings Mud Park on the 20th. Next Saturday....
  22. 98slv

    6 inch lift

    I've tucked 37s under my RCSB with only a 6 inch lift. But like stated above, you'll have to cut quite a bit to clear or they will rub.
  23. 98slv

    New member from TEXAS

    O dear! That truck looks so good! Welcome to the site!
Top