Search results

  1. M

    4wd engagement leads to pulling to the right

    It was finally almost in the 30s here today so I pulled it into he garage, and lifted all the wheels off the ground. It's goes into 4wd front driveshaft is spinning, however I can stop either wheel with my foot by dragging it and the other side will continue to spin, at one point I had both...
  2. M

    4wd engagement leads to pulling to the right

    I'll do that tomorrow, I'm a little confused about the actuators. So the truck being a 98 should have the updated electric actuator correct?
  3. M

    4wd engagement leads to pulling to the right

    I have a 98 k1500 5.7/4l60 that has a rough country 6in on some crappy 36in tires atm. The issue I'm having is if I engage 4wd hi(haven't tested low) the truck will pull to the right bad. I've only engaged it on a dry road and yes I know that's not recommended but I'm just testing the system...
  4. M

    No heat, not sure what the problem is.

    My heat issue was my heater/ac control unit. It was kind of obvious when I looked at it upon removal one of the wires on the circuit bored was fried. New unit and I've got heat again.
  5. M

    No heat, not sure what the problem is.

    . P Thanks a ton for this information ! My actuators are moving 1/10 of that range, I'll get my multimeter out and do some testing today.
  6. M

    No heat, not sure what the problem is.

    No I haven't checked that yet, it's on my long list of stuff. Just didn't seem right with the actuators moving so little.
  7. M

    No heat, not sure what the problem is.

    I recently acquired a 97 k1500, and then I found out the heat didn't work . I had an 05 Silverado years ago and had replaced the blend doors in it so I kind of just went that direction with some cheap ones off Amazon. So I started off replacing the one for the vents near the gas pedal...
Top