Search results

  1. rhino

    P0785 Shift Solenoid

    Which solenoids did you replace? The back two shift solenoids? Code PO785 is for the 3/2 Downshift Solenoid. It is in the front. If you put the right solenoid in, for sure ohm the wire from the PCM to the Transmission. If you need a wire diagram let me know.
  2. rhino

    Weird 4l80e problem.

    Check the brake switch. It would account for no lockup and no cruise. If that isn't it, look at the TPS. But I bet that brake switch is it. The only place the fluid can go is in the radiator if it isn't going on the ground. But.... my bet is the brake switch is stuck on, causing no lockup...
  3. rhino

    Need Help Tracing VSS Wires

    Good question. They are for sure always twisted though.
  4. rhino

    No clutch pedal pressure!!

    Give me a call tomorrow. It looks like you are right up the road. I will help you out if I can.
  5. rhino

    Nv3500 broken slave cyl. bolt.

    ehhh. that will be tough to rig up.
  6. rhino

    Need Help Tracing VSS Wires

    If my memory serves, the buffer is behind the glove compartment. It is a little white box. The speedo wires run to the buffer, then the signal is split from the buffer to the cruise, dash, and PCM. I believe the pigtail you don't know where goes is the 4x4 light switch on top of the transfer...
  7. rhino

    Dumb questions

    Leave the rubber, it is a lube passage. It lubes the rear tailhousing bushing. The bellhousing bolt pattern is different, but I have seen them swapped.
  8. rhino

    1997 Z71 4L60E Issue

    honestly it sounds like a drivability issue. I would start with a fuel filter.
  9. rhino

    Nv3500 broken slave cyl. bolt.

    Does it look like this? If so yeah.
  10. rhino

    Safe to drive with broken sunshell/sungear?

    The shell is on in 2nd and 4th as well as reverse. That is the reason it didn't want to shift. You almost have to lift off the throttle so the throttle position sensor will let it skip over 2nd and get to 3rd. Also don't worry to much about the mysterious friction. That year was hell on...
  11. rhino

    Safe to drive with broken sunshell/sungear?

    Love this post! I have seen people drive around with a stripped shell for months. It will eventually stop the whining after week two they say haha. Are you doing a full build or just a shell and seals? That's a nice looking ride.
  12. rhino

    Explosion

    It was pretty weird. It was an older gentleman that said he was headed to church and heard a "pop"!
  13. rhino

    Explosion

    They will drive them to the last mile lol! Where is your place?
  14. rhino

    Explosion

    Man that is awesome news. I poke my head in and catch up when I can. It's been a busy year down here in the Sip!
  15. rhino

    Explosion

    Check out this guy. It is unbelievable that this guy drove to the shop with just a slip and a rattle!
  16. rhino

    4L60E Transmission Rebuild

    I would add a Pressure Control Solenoid, 2- shift solenoids, Vette Servo, 3/4 Molded Apply Piston, and maybe an Input Sprag. It wouldn't be that more expensive to hit those problem areas now rather than later. Oh I just saw it is a 99, For sure put something for the TCC regulator valve. They are...
  17. rhino

    1999 Suburban 4l60E 2-3 flare with a twist

    It sure sounds like you don't have long at all. I would be planning a rebuild on that one pretty soon. Although, I have seen some strange things like a 2/3 shift valve hang ever so often causing a no 2/3 shift. It is rare however. Another common problem is the servo release ball sticking. It...
  18. rhino

    Dipstick measurement

    That should be fine. Usually anything under the squiggly little part in the stick is ok. If you're ever under there again I would make sure the vent hose is connected to the vent pipe on top of the transmission and run down the driver side away from the exhaust. The 99's had a TCC slip problem...
  19. rhino

    99 transmission into a 97?

    Hey dude, I have never done this swap, but I have seen it done several times. I am glad you got it in and working. What shift cable bracket did you use? I would use the one off the 97. Maybe try which ever one you didn't use to see if that fixes that shift issue. That, or the clip simply isn't...
  20. rhino

    Shop refused to service transmission - Find another shop or Thank them?

    Nobody knows. It would be cool to say, ok every car over 200 thousand miles shouldn't be serviced. But, its not that simple. It's a case by case basis. A few things I look for is, is the fluid burnt? Burnt fluid is bad right? Well kinda. If you have a 200, 000 mile car with the original...
  21. rhino

    Need help, no 4th gear or torque converter lockup

    Check that servo. Make sure you didn't pinch the outer oring that goes into the cap. That is your 4th gear.
  22. rhino

    Emergency help Columbus OH area

    Not sure if you still need this, but my WIT rep gave me this guy. Said they were an honest, long term shop. METRO TRANSMISSIONS 3699 AGLER RD. COLUMBUS OH 43219 ATTN. MATT 614-476-6647 I HOPE THIS HELPS!
  23. rhino

    HELP!!!! 1995 transmission in a 1998?

    If money is a huge issue, then take the 3/2 downshift sol out of the 98 model transmission, install it in the 95 model transmission. You can shave the notch off the wiring harness so it will plug in (you will see what I mean when you look at it). The 95 3/2 solenoid ohms at 10-15 ohms. The 98...
  24. rhino

    Upping the stall speed on my 96 4l60e 4x4

    I don't think going up in stall is really going to be that big of a difference. I doubt you would even be able to tell with that setup.
  25. rhino

    How long did your 4L60E last?

    2007 GMC Sierra lost 3rd and 4th at 170,000 behind a 5.3. Built back with Z-Pak, beast shell, jr shift kit, superior super servo's, wide band, new rev input drum, and 5 pinion planet kit.
Top