Search results

msd 6al, delete the icm

building a wiring harness for a hot rod and using 0411 ecm and vortec 5.7 harness. can i remove the solid state ignition control module and use an msd 6al in place of it since the msd is an ignition control module in itself. the white input wire on the 6al would go to the pcm pin 26.
- GreenChevelleSS
- Thread
- Dec 10, 2020
- Replies: 0
- Forum: 96+ Vortec Performance + Computer Swaps
96+ temp gauge sender

So has anyone found the correct temp gauge sender yet? Id like my gauge to read correctly. Ive searched on here and it seems to be a lost cause. Im wondering if anyone has ohmed out the gauge and different sensors to find a match since the new ones dont match. Ive even tried from the dealer and...
- GreenChevelleSS
- Thread
- Nov 24, 2016
- Replies: 4
- Forum: Engine Performance + Maintenance
Dual rear axle vs Single wheel axle width

I have a 2000 K2500 single wheel that has the Semi floating 14 bolt with 3.73 and locker. I have a rear end from a dually truck that is a full floating 14 bolt with 4.10s and locker. Whats the width difference between the two? Id like to swap over the the full floating and 4.10s and change the...
- GreenChevelleSS
- Thread
- Oct 24, 2016
- Replies: 4
- Forum: Axles + Brakes
6.0l 2000 Crew Cab SB 4x4

Been building this for a few months still a long ways to go but I fired it up tonite.
- GreenChevelleSS
- Thread
- Oct 15, 2016
- Replies: 38
- Forum: Member Trucks
Tailshaft support on 2000 CCSB

Has anyone seen anything like this before? Its on my 2000 Crew short bed 4x4. Looks very factory and not added. but whats also weird is the tcase is a 243 thats behind a 4l80e. Ive never seen that before either. RPO codes in the glovebox shows its supposed to have a 263 tcase but the 243 looks...
- GreenChevelleSS
- Thread
- Sep 6, 2016
- Replies: 7
- Forum: Transfer Cases
New from tulsa oklahoma

Decided to join. Ive built probably 10-12 of these gmt400 trucks and have boxes of parts. I finally got one i think im gonna keep. its a 2000 crew cab short bed 4x4. Im doing a lq4 swap with it. I currently have a 96 z71 that ive had for about 16 years and a 2000 s10 zr2 with a vortec 350 and...
- GreenChevelleSS
- Thread
- Aug 29, 2016
- Replies: 10
- Forum: Introduction
96 4l60e Delayed engagement and harsh 1-2 shift

Ok so I had a 4l60e transmission laying around. Took it to a trans shop and had it rebuilt for my truck as mine was starting to shudder and 1-2 slip when shifting. (I used shudder fix alot in it). After it was rebuilt and installed I started getting a p1870 code and going into limp mode, it had...
- GreenChevelleSS
- Thread
- Aug 29, 2016
- Replies: 1
- Forum: Transmissions