I have a 1991 c1500 with the 5.7 and my drivers side Lear spring is sagging more than the pasanger by about an inch. I was thinking about swapping them out with some springs off a 2000 model truck. My springs are a 3 leaf + over load and the newer trucks are a 2+ over load. I don't do any towing so I'm not worried about any of that I assume it will lower the back a little considering there will be one less spring. I'm fine with that just want to know if any one has done this and if they will fit?
Leaf spring swap?
- Thread starter 91 c1500
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Lanny
I'm Awesome
Im not sure if they will fit but you will have to take some measurements. First, start with the lengh and width. If they are the same uncompressed length then you're off to a good start. If the width is the same as well thats crucial. Im going to go ahead and assume that they wont be identical. Its a different genoration truck running on a different platform. You would have better luck with a GMT-400 truck spring.
Similar threads
Members online
- Andersonz711
- truedual93
- tahoedude
- hoodshy
- FknReaper
- 454C2500Longbed
- CrustyC1500
- Supercharged111
- 95RCSB
- TowManJohn
- 2DoeProjectHoe
- theoneandonly
- KendallConnor
- Jim83GMC
- scott2093
- 1998_K1500_Sub
- Zakgray98k1500
- AirMdwn
- SNCTMPL
- jdonnell
- Aidan Kesler
- John Moore
- Chevylife85
- 618 Syndicate
- RichLo
- 89RCLB
- Gorillanuts84
- rosert
- PlayingWithTBI
- BoostedKyle
- Wh4t3v3rs
- LCALDERA98
- Pinger
- tswii
- Danimal08
- twebuh
- Alteca
- kdhs10
- Bachert24
- Loud1500
- warpig98
- Keeper
- gbw83
- vince72
- Drunkcanuk
- Frank Enstein
- scobbyrows
- hclanton93
- 0xDEADBEEF
- BonestockK1500