Guys need some remote start wiring help

FIREBALL 94 said:

Ok so I got some of my python 5106p wired up but the remote start wires are throwing me a curve ball? Ok so here’s what I thought so y’all chime in and tell me If I’m thinking right cause my headache is not helping any on the thought process today, lol. So I need some help guys I also posted pics of the full layout of all harness/paperwork below.

So this is what I have so far.....on the 10-pin remote harness

H3/1 pink —— to pink wire on steering ignition harness
H3/2 red/white —— not used?
H3/3 orange —— to orange acc wire on steering ignition harness
H3/4 violet —— cut purple wire on steering ignition harness ( this goes to the one side goin to starter)
H3/5 green —— this goes to the other side of the cut purple wire on ignition harness
H3/6 red —— not used?
H3/7 pink/white —— not used?
H3/8 pink/black —— not used?
H3/9 red/black —— not used?

Now on the other 24 pin harness here’s what I got

#4 —black/yellow ——wired this to a relay and tied dome wire off of dimmer switch white wire for a signal
#9 —grey —— wired to hood pin switch
#12 —violet/white —— wired to one of the white wires off the ignition coil....? (Is this correct for tach signal)?
#13 —black/white —— wired to ground under dash....
#16 —Brown/Black —— wired to oem horn black (-) wire on steering column ignition harness
#20 —Brown —— wired to white (+) at brake switch under dash

As for the Main 6-pin and 3-pin door locks harnesses are done got them covered .....am I missing anything for basic wire up? Thanks in advance guys and I really appreciate any help with this .......

You must be registered for see images attach

You must be registered for see images attach

Click to expand...

str8fan7 said:

what year is this on? for my 94 I went to www.modifiedlife.com/1994-chevrolet-silverado-remote-start-installation-chart/ and no issues with it at all

Click to expand...

FIREBALL 94 said:

Mines a 94 too but after hooking up the above wires under the dash to the proper wires, the alarm brain will click and then nothing?? So I’m still trying to figure out why? So apparently I’ve got something not right......

Click to expand...

str8fan7 said:

this isnt the correct way, take the wire for the neutral safety switch and ground it. ours have mechanical switches
it WILL start in gear

Click to expand...

FIREBALL 94 said:

If ur talking about the number 13 wire on 24 pin harness, I did ground this wire?

Click to expand...

str8fan7 said:

I actually put a screw in the firewall with #13 wire(black/white). It was the only way I could get my remote start to work. It's suppose to go to the neutral safety switch ground side, but our trucks have mechanical neutral safety switches

Click to expand...

FIREBALL 94 said:

Ow ok I got what your saying I’ll try it when I get time I appreciate it

Click to expand...