What should I do / replace while the dash is out

jollyjerry · Jun 26, 2017

Dropping the dash because I think the evaporator is leaking coolant, but figure I'll do some other stuff while the dash is out. Any thing you wish you had done when the dash was out?

Inspect / replace heater core
Clean out ducting
Dynamat / seal for rattles and road noise
Clean mode actuator doors (they stick)

I'll add on to this list as I go along too

grampadirt · Jun 26, 2017

I wish I would've done a better job of cleaning around the heater core & evaporator,it all works good but I think it could be better.You have that covered though.

jollyjerry · Jun 27, 2017

Added hummingbird fuel gauge fix. Also going to reset my temp gauge and oil pressure gauge to read what the ECU reads.

Dubs · Jun 28, 2017

put new seals around your hvac box, inside and out. clean the metal dash of the truck where it meets the windshield.

kv5137 · Jun 28, 2017

Check all your harnesses

Sent from my iPhone using Tapatalk

run96k3500 · Aug 12, 2017

Take the entire AC box apart, check and make sure the blend doors inside are in good shape. The rubber seals connected to the plastic doors flaps on mine were completely dried and cracked. I didn't get new ones but I will next time the dash comes out. I did apply rtv gasket makers to the whole thing to keep a better seal.

Sent from my iPhone using Tapatalk

What should I do / replace while the dash is out

jollyjerry

I'm Awesome

grampadirt

On MEDICARE Officially Old

jollyjerry

I'm Awesome

Dubs

I'm Awesome

kv5137

I'm Awesome

run96k3500

I'm Awesome

Similar threads

Latest posts

Members online

Forum statistics

Share this page