Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I have a dumb question.
Is the 411 repin different if your running the factory 350 vs doing an LS swap? Meaning would the pins be relocated to different positions depending on engine used?
Thank you Jeff. Now knowing that it will work is there different pin out sheets for that ecm versus the 0411? My plan is to convert straight to an LS not using the Vortec 5.7. Would i modify the Vortec harness to fit the LS or would i modify the LS harness to the Vortec? I would like all of the factory suburban dash and abs to work. Thanks again.
Ok that works. Will this ecm work with a drive by cable set up? I understand the ecm has to be reflashed, but can you tell me what all has to be done in the ecm? Again, i will be running the 5.3 LS not the vortec. May I pm you in regards to the pin out sheets?
Ok thanks. Can you please send me the wiring info needed to do the Gen 3 swap. I'm sending you a pm. Thank you for your help. Chris
