Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Thanks!Absolutely agree, a truck is truck no matter how pretty or tricked out they are. But anyways the farthest one to the door on the left is for extra support, the two in the middle are where it appears that the armrest was molded to the panel from the factory, and the screw in the handle is a longer, stronger screw for more support. The washers are so that the bigger screw doesn't rip any of the plastic in there. The outer three are just 3/4 or 1in self tappers.
You must be registered for see images attach
You must be registered for see images attach
Best part about it is, it's already broke, so you can't possibly mess it up.
No problem hopes this helps!
Sounds like you got-er-done. She ain't going anywhere it doesn't sound like lol.maybe i will grab a pic tomorrow if i remember...but I was able to drill out the factory pin locations and put in a #12 x 1/2" screw in each location, and then i put in about 6 more of the same elsewhere to further reinforce it. AND i gooped the crap out of the bottom and back side with some left over 2 part seam sealer i had. I hope it doesn't come apart, not pretty from the back side but no one ever sees that
once it is back on the door i will probably still put a screw in the front and the back side of the armrest and/ or a screw straight down through the unused hole in the steel (possible for a GMC or just an older model 88-89?)
For the door panel or the arm rest?
