FastOrange
OBSless
I had to trim with a 4" spindle and 3" body with 35w
12.5s on stock wheels. I doubt he could run aftermarket wheels with 315s
Sent from my SM-G920W8 using Tapatalk
Grandpa's 1995 C1500 Reborn
- Thread starter 95C1500
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
12.5s on stock wheels. I doubt he could run aftermarket wheels with 315s
Sent from my SM-G920W8 using Tapatalk
MDR-97-Z71
400 Obsessor
Hhhmmm.. Is it the spindles or frame differences that make it difficult? Cause he said before his fender height measurement is 39" and mines not even fully cranked at 38". There's even a local 4x4 400 in my area that runs 315 M/T's on 2" spacers and I don't even think it's fully cranked.
Sent from my 5.7 powered iPhone
no thanks 
It comes very close to rubbing the bumper as it sits right now (when turning). I need to trim some of the bumper for peace of mind
1995z71
OBS Enthusiast
Truck looks good, how do you like the two light bars behind the grille?
Hey I just posted in your thread about this haha. I love em. Looks really clean this way. Light output isn't great BECAUSE they are flood lights. I just wanted to get everything set up behind the grille. I'll move them down to the valence area and replace them with spot beam bars later
BowtieBrody
Jesus Murphy!
Where'd you buy 'em from? I've been looking around to try and get my rear stance out a little bit,
Torchred
Carolina Can
I ended up buying his lift lol. Sorry about the deal with the spacers, no clue how long before I get a set of wheels for my truck.
