Recent content by Yukon GT LS
-
Y
Holley 12v and brake tap in
Where are the best places to Tap in for 12v switched?? I have the holley terminator itself to a wire under dash but I need 2 other separate places to tap for 12v switched for DBW holley and the Transmission harness...the last one I need to know where to tap into easiest is for the brake pedal...- Yukon GT LS
- Thread
- Replies: 1
- Forum: Audio + Electronics
-
Y
96 Yukon GT wont turn over
Could it possibly just be the crank fuse that's bad? Have not checked yet- Yukon GT LS
- Post #8
- Forum: Engine Performance + Maintenance
-
Y
96 Yukon GT wont turn over
First startup...haven't setup any of the holley yet the holley ecu sn't even connected...I jist wanna get the truck to turn over at the key first then I'll setup the holley and start the car- Yukon GT LS
- Post #6
- Forum: Engine Performance + Maintenance
-
Y
96 Yukon GT wont turn over
There's power at the big red wire feeding the relay board when key is off...I am running that purple under starter relay over to starter for signal...when I turn key nothin!- Yukon GT LS
- Post #4
- Forum: Engine Performance + Maintenance
-
Y
96 Yukon GT wont turn over
It's a 6.0 LS and 4L60- Yukon GT LS
- Post #2
- Forum: Engine Performance + Maintenance
-
Y
96 Yukon GT wont turn over
Terminator x max wired up...stock ecu and harness connected...just trying to get starter to turn over at key...it won't! I did jump starter and starter is good... I tried to plug back in the neutral safety switch still nothing!- Yukon GT LS
- Thread
- Replies: 8
- Forum: Engine Performance + Maintenance
