Thanks for the reply.
It does have the auxiliary valve body. I decided to leave the piston out and installed the constant pressure valve body per TCI's instructions and haven't had any problems with it.
I have a 91 C1500 with a 700R4. I ordered the TCI constant pressure valve body kit since I installed a Holley sniper unit. I pulled the valve body, seperator plate, and gasket but I never found the 3-4 accumulator piston or pin. Looking at the seperator plate it doesn't look as though it was...
Thank you, the terminal ends must have been damaged at some point because the wires were just twisted together and tightened down underneath the bolt head.
I have a 91 that came with a 5.7 that I'm swapping out. While pulling the engine harness there were 2 wires that were grounded to the the thermostat housing, one black and one black with a white strip. The wires are routed with the coolant temp sensor in the intake. Can someone tell me what...
It's a GM crate engine I purchased through Pace Performance. I believe GM calls it a "357" cam.
GM advertises it as a 350/357 deluxe I believe, Pace advertises it at 390 hp.
Here is the link to the engine...
This is what I found at Advance, is the correct S10 convertor?
PRODUCT APPLICATION
1998 Chevrolet S10
4L60E Transmission; Lockup; 12.5" Diameter; 30 Splines; 1.703" Pilot; Slotted Hub; 3 Lug Mount; 11" Bolt Circle; High Stall
SPECIFICATIONS
Bolt Circle Size: 11 in
Diameter: 12.5 in
Fluid...
Swapping in new crate engine in my 91. I'm looking for a recommendation on what stall I need for my setup.
700R4
3.73 gears
Camshaft: Hydraulic Roller
Cam Lift: .473” Intake / .473” exhaust
Cam Duration @ .050”: 215 deg. Intake / 223 deg. Exhaust
Lobe Separation: 112.5 Degree
Cylinder Heads...
I have a 1991 Silverado that I want to swap a 383 with Fitech in, is the Walbro 255LPH the fuel pump I need for this conversion or is there a better option available...
If this question has already been asked I couldn't find it in the search function. I have a 91 RCSB with a 5.7, thinking of replacing the engine with a pace performance 383 crate engine with Fitech 600hp system. Is there any way I can use the factory gauges with the Fitech?
I recently bought a 1991 Silverado and just noticed that the A-pillar trim is broken completely into above the drivers side window. I was wondering if this trim piece is specific to Silverado's or do all the GMT 400's have this same trim? I found this one on Ebay for $80 plus $30 shipping. The...