Recent content by RedLeader289

  1. RedLeader289

    Another TBI running rich

    My truck has the EXACT same issue. Here's to hoping you've figured it out!!
  2. RedLeader289

    engine cranks, won't start.

    If the engine was running fine why were you messing with the timing? It sounds like you unplugged the ICM. Pull the #1 spark plug, ground it out, and have someone crank the engine. If it doesn't spark then your ICM is either unplugged or has failed.
  3. RedLeader289

    Factory Steelies & Hubcap Question

    They're just standard 16" Chevy rally wheels. You can find them just about anywhere.
  4. RedLeader289

    GMT400 Picture Game!

    Got it. Next - yours in a parade (either pulling a float, converted to a float, or just in a parade)
  5. RedLeader289

    RCLB K2500, K3500 Differences?

    Just an FYI, the heritage center document is scuffed on the max trailer weight for the K2500 HD. At a swap meet I found a hard copy of the document (but didn't buy it because the guy wanted $25 and wouldn't budge. . . .). The max trailer wt (tongue trailer) for a 8600GVWR K2500HD is 9,500 lbs...
  6. RedLeader289

    RCLB K2500, K3500 Differences?

    If you're comparing the 6 lug 2500 to the 3500 (8 lug standard) then there are a lot of differences, including the frame itself. However, when you put an 8-lug 2500 next to a 3500 it gets a little murkier. The frames are the same, you could order the 2500 with the same springs/etc. Heck, the...
  7. RedLeader289

    Is it worth getting TPMS?

    I'd pass. You can feel when a tire is dangerously low, and if you check them regularly like you do your fluids then it's just $200 leaving your pocket.
  8. RedLeader289

    ?? 10 Bolt - 12 Bolt - 14 Bolt ??

    Don't worry about the extra weight, just think of it as traction.
  9. RedLeader289

    ?? 10 Bolt - 12 Bolt - 14 Bolt ??

    If the local 14-bolt is in good shape I'd lean towards doing that. There are certain areas where overkill isn't a bad idea (brakes, rear end, etc).
  10. RedLeader289

    Plasti-Dip or Bedliner for the lower body panels?

    plasti-dip is quick but doesn't hold up, rocks will chip it. If you're wanting to do a coating then go with the bedliner, although if moisture gets behind it the panel will rot away and you won't notice it until it's too late. They make adhesive stainless steel panels that are cut to fit the...
  11. RedLeader289

    Growling noise in 4x4 - axle or wheel bearing?

    My guess would be the CV joints. Had a similar issue in my jeep and that was the culprit.
  12. RedLeader289

    Value of our trucks

    Nice. Good luck with the sale!
  13. RedLeader289

    Value of our trucks

    A little detailing work would do wonders on that truck, even with the paint in the condition its in. Buff the headlights, spray out the floor mats, give everything a good wipe down.
  14. RedLeader289

    Value of our trucks

    So, for what it's worth I got my truck appraised for insurance purposes (stated value coverage FTW!) about a week ago. It appraised for $7,500 and I was told to bring it back in 2 years when I get antique tags because the value should increase. Reputable appraiser, in the business for the past...
Top