Yes, that is what i'm doing. Got spindles from a 06 gmt800(or lowered spindles). Lower control arm from a 2000 2500, you have to ream out the upper ball joint in the spindle to fit the stock upper control arm of the GMT 400 truck. The lower control arm will fit no mounting mods. Then you just...
Well I just started by wanting to upgrade my fuel pump. Them noticed fuel tank crossmember bad. Them found LS 5.3, with a stage 2 cam for it. Them how to modified front for bigger brakes. Decided I'm going the AWD lowered route with it also. Now it all just falls apart and ready to get more...
Well order my calipers. Got a set of spindles and started on the truck. I'm lowering and engine swapping to as I go. So will keep everyone updated as I do the install. Sorry she's alittle dirty.
I haven't ordered anything yet. But my research I've been reading. You use 03 truck spindles you have to use a 10 degree reamer to ream holes for gm 400 ball joints to fit the gm800 spindles. Sean tgat the 4x4 ones can even use tge gm800 wheel bearings with gm 400 axle shafts. When using the...
So been doing some looking and what not. I'm getting ready to start on my project and was wondering if this is possible and if has anyone done it??? So what I was thinking, I have a 1996 scsb truck. i seen where you can put 03-06 spindles on these trucks. So with that being said. You can modify...
I am having the same issue. Just picked up a 1996 RCSB 4x4. I cant get the computer to enter programming mode. What is the RPO code to verify if it was optioned for my truck. thanks again for the help
Hey guys, Looking into this mod for my 2 trucks. I have a 96 k1500 and 2000 c2500. Would love to get the info for this. My email is [email protected]. thanks again for all your help, now and in the future.