Sorry if I didn’t provide enough information! As I said some of the bolts in the bed of my truck were missing. it is a1994 GMC C1500 Stepside 5.7! Here is an actual picture of my bed where you can see missing bolts/screws with torx head. Not the typical bed mounting bolts found everywhere when...
The truck I purchased is missing a few of the bolts/screws shown in the picture In the bed. Does anyone know the size and where they might be available? I have looked everywhere. Doesn’t look like LMC or NPD has them!
I purchased new clear headlight covers due to the ones I have being all scratched up. It looks like there are small metal clips holding the cover on and apparently there are spots for four of the clips on each headlight. I haven’t taken them out yet to replace yet but wondered where I could find...
What do you think these wheels should be worth? I found them at a yard sale, they have new chrome and center caps. The were sandblasted and repainted silver. 15x8 inch. I haven’t purchased yet but the fellow was asking $400 but said he would bargain a bit!
I have a 1994 GMC stepside I have been working on and I would like to repair this back section on both sides but not sure what to do. I believe Bondo, painted with a rattle can would look better than the way it does now. Any ideas? I gues it needs to be the flexible stuff? The first picture is...
So glad to find this post! My 94 sierra speed sensor was leaking around the o ring so I got a Dorman replacement and it made a whining noise as described above. I also then ordered a ACDelco sensor but upon inspection I found the same issue the magnetic bars were protruding out past the housing...
I ordered one of the 40 dollar ones off eBay and much to my surprise I did not have to torch the shaft to break loose the plastic thingys. The shaft I got was new and was for 84-94 jeep Cherokee. The shaft would move in and out 2 1/2 inches. My shaft was about 19 inches bolt center to bolt...