Recent content by Jeffgmcgrr

  1. Jeffgmcgrr

    Two more whimsical questions. I'm sure my name's by now

    I do have a tow package on the receiver. That brake light goes out on both the truck and trailer when it goes out. However as soon as I press right turn signal it kicks back on
  2. Jeffgmcgrr

    Two more whimsical questions. I'm sure my name's by now

    First question, my heater doesn't seem to be actuating from mid, floor , defrost. It's stuck on mid... anybody have any tips and tricks for accomplishing this one? Next..... I have a short, my left brake light will come in and out. I've also noticed that if it's out, and I engage my right...
  3. Jeffgmcgrr

    Electrical - Anyone make sense of this..? where you at Skylark

    I did buy or get a new battery warranty deed as well as made sure to run all grounds to spec
  4. Jeffgmcgrr

    Electrical - Anyone make sense of this..? where you at Skylark

    No progress on the battery light, however my hot start issues have went away. My last problem is an extreme flex plate chatter. Originally thought it was the transmission I put in used but my fears were quieted.
  5. Jeffgmcgrr

    Electrical - Anyone make sense of this..? where you at Skylark

    Well I rerouted everything. The main ground is now on the number two intake bolt. The braided copper cable was cut in half but I'm mended it with a splicer for now and attached it, the firewall ground just kind of runs into the the harness. Can't tell much there. My truck is firing right up but...
  6. Jeffgmcgrr

    this may be dumb but 4l60E in 1992

    Alright I answered my own question. Although it was made in Toledo, I do have a 700 R4. I guess the 4 pin connector is a dead give-away
  7. Jeffgmcgrr

    this may be dumb but 4l60E in 1992

    Most articles online say the 4l60E was introduced in 1993-xxxxx My question is, are there some 1992 GMC Sierra there have the 4L60E and not the 700r4/4L60?? My truck is a 92, here is a picture of the transmission I pulled. Which coincidentally is made in Toledo, which is the same place they...
  8. Jeffgmcgrr

    Electrical - Anyone make sense of this..? where you at Skylark

    It's about 13.4 with headlights etc.. at idle
  9. Jeffgmcgrr

    Electrical - Anyone make sense of this..? where you at Skylark

    this is the big cable coming from my battery it's down to the frame as you can see you.. when you say intake bolts should it be going to an intake manifold bolt instead?
  10. Jeffgmcgrr

    Electrical - Anyone make sense of this..? where you at Skylark

    Sky... I saw a comment of yours in a different post. When it comes to the negative ground positions... I have the battery post and then a small ground heading passenger side fender and then the bigger ground goes down and bolts to one of the frame bolts passenger side engine. My question is...
  11. Jeffgmcgrr

    Electrical - Anyone make sense of this..? where you at Skylark

    I haven't messed with it yet but when I tested the battery before hooking it up it gave me 12.6. I started the truck and it jumped to 14.3 or 4 and then over about 5 minutes of idle that droped down to about 13.9. After I turned the key off I tested the battery and was now at 12.9. To be...
  12. Jeffgmcgrr

    Electrical - Anyone make sense of this..? where you at Skylark

    Coincidentally... I ran my battery to the shop to have them test it and it came up.bad, luckily within 2 yr limit so was warrantied. I did happen to buy a cheap voltmeter and light circuit while I was there, I hadn't read this yet. For now my battery light is still on after installing new...
  13. Jeffgmcgrr

    Electrical - Anyone make sense of this..? where you at Skylark

    I'm having a hard time understanding why my battery light is on. Furthermore there seems to be a drain on my engine when the truck is off. While idling the system is charging at 13.7
Top