building a wiring harness for a hot rod and using 0411 ecm and vortec 5.7 harness. can i remove the solid state ignition control module and use an msd 6al in place of it since the msd is an ignition control module in itself. the white input wire on the 6al would go to the pcm pin 26.
sucks all my pics are gone. put nearly 30k miles on it and love it. upgraded to lsa injectors and its much better. was running the gtp injectors and they were not enough, my injector duty cycle was over 100. ive also swapped to the smallest pulley that can be fitted on the radix without...
What? steering geometry? did you read what i posted? have you compared the k2500 LCA between the 400s and the 800s? cause i have both and they are identical except what i noted in my previous post which has nothing to do with steering geometry.
they are the gmt800 arms
"Its an almost identical forging, but the differences are the lower ball joint mounting bore, the shock bracket mounting area has larger bolts on NBS, and they are moved slightly apart. The mounting area is also flatter and kicked off at less of an angle as the OBS...
Has anyone done this on their 2500 and experienced the ride being a hell of a lot rougher? I did the NBS brakes, spindles and LCAs and now the front suspension is so stiff it sucks to drive. Its not the tbars cause i marked them and put them back where they were, and ive cranked them down and...
Got to tinker with it a little. Installed the ebay intake pipe and filter and finished powdercoating my nbs a-arms and spindles and installed energy suspension bushings.
Havent got to mess with it lately between dealing with being sick and getting my supra cleaned up and entered into the starbird show ive had no time or energy to finish it.
Its alive. Keep having problems with the fuel rail crossover fittings leaking. I might have to convert it to AN and run a braided line. But heres some noise for you to drool over
Thanks guys, still a lot of work to go to make the truck nice but its slowly getting there. Ive picked up a set of NBS front brakes and spindles. working on getting them powder coated and going to new energy suspension bushings, bilstein shocks, new moog ball joints.
Well things changed a little. sold the whipple and bought a magnacharger. now if it just cleared the hood id be good. time for a Cowl hood? also pulled the headers back out and installed v band clamped and then got them ceramic coated. Im happy. one thing at a time cant wait to fire it up.
also...