Recent content by edonwheels

  1. edonwheels

    Electrical Gremlins ready to burn down the truck

    Mine was doing the same thing it was a power wire from the battery to the trailer brake. The header melted a spot on the wire and it would only do it on rough roads. Sent from my LGL164VL using Tapatalk
  2. edonwheels

    The Stupid Engine Questions Thread

    Any improvement or advantages to this swap? Sent from my LGL164VL using Tapatalk[/img]
  3. edonwheels

    Code 43

    Mine is a 94 k3500 7.4 Sent from my LGL164VL using Tapatalk
  4. edonwheels

    Code 43

    Where does it show the esc? Where my book says it should be it's not there. Sent from my LGL164VL using Tapatalk
  5. edonwheels

    Code 43

    My multimeter is showing power on the wire and I put in a new knock sensor but I still have code 43. Sent from my LGL164VL using Tapatalk
  6. edonwheels

    Code 43

    I was looking at it wrong 88-93 it was in a different spot and the diagram shows both. Sent from my LGL164VL using Tapatalk
  7. edonwheels

    Code 43

    I replaced the sensor and fixed the wire but still getting the 43 code. So I ordered a repair manual that came in today finally (Idk why I've waited this long to get one). Ten minutes into it I figure out why I'm still getting code on mine the 7.4 has 2. So I'll probably be ordering another...
  8. edonwheels

    The Stupid Engine Questions Thread

    Could be a speed sensor. I know the one on the transfer case can affect shifting. I had to put one in my 94 it would go into nutral while driving. Sent from my SCH-I545 using Tapatalk
  9. edonwheels

    The Stupid Engine Questions Thread

    What does your transmission fluid look like? Sent from my SCH-I545 using Tapatalk
  10. edonwheels

    Code 43

    I got it too then looked at the knock sensor and wires are gone. I also read wire could rub and cause the code to come on. Sent from my SCH-I545 using Tapatalk
  11. edonwheels

    What have you done to your gmt400 today?

    Idk why it didn't show when I searched admin can delete it. Sent from my SCH-I545 using Tapatalk
  12. edonwheels

    Flat tappet

    I was researching motor oils here's the article. https://www.google.com/amp/www.hotrod.com/articles/pit-stop-small-block-chevys-came-stock-roller-cams/amp/ Sent from my SCH-I545 using Tapatalk
  13. edonwheels

    Flat tappet

    Just read an article stating gm didn't change trucks to roller cams until 1995. Can anyone confirm this? Sent from my SCH-I545 using Tapatalk
  14. edonwheels

    No interior lights with door opened

    Yeah I tried it I'm thinking it may be my problem. Sent from my SCH-I545 using Tapatalk
  15. edonwheels

    No interior lights with door opened

    Just got a 1994 crew cab dually the interior lights don't come on with any of the doors open but they all work with the dimmer switch. Would one of the door switches make them not work or just the auto switch for the interior lights. Thanks for any advice Sent from my SCH-I545 using Tapatalk
See more

Latest posts

Members online

... and 6 more.
Total: 1,448 (members: 56, guests: 1,392)

Forum statistics

Threads
64,315
Messages
1,391,206
Members
51,406
Latest member
Mako199

Share this page

Top