My 97 suburban trans has been recently replaced and it's still acting the same before I replaced it. Works fine until the vehicle gets warm and is drove around for a minute. Once it gets warm the trans will hardly pull or not at all. Thoughts?
Sent from my iPhone using Tapatalk
What headers do they make for a 95 z71 to go with an ls swap? I've read somewhere somebody makes some for us obs drivers. Anybody know?
Sent from my iPhone using Tapatalk
Thanks for the help. Just seriously wondering about the trans. I was wondering if I could just leave the old harness in it and let it control the shifting.
Sent from my iPhone using Tapatalk
What all do i need to preform the swap?
I've read a little bit have a few questions.
Will my stock 4l60 work with correct spacers and flex plate?
Will I have the trams shift points changed from stock?
Any links or threads that can help me would be awesome. I do plan on making the motor a...
My truck has began to backfire while going up hills and while under load. It's backfiring through the tbi. It has 217k on the original motor and trans. Anybody know of a good place for to start to look for a fix.
Sent from my iPhone using Tapatalk
I have the 350 tbi and I'm looking to replace my motor. Mainly looking to do either a long block or buy one from an individual. Can anyone help me in telling me which years i could a tbi from and it be a direct replacement into my truck?
I've recently had my a/c stop working in my truck. I've replaced the low side accumulator switch, accumulator, low & high valve fill ports, most all of the seals. ran leak detector through it and found nothing around the r4 type compressor. will not hold a full vacuum at full pressure for long...