Maybe someone can help with where to start with this. 99 tahoe approx 110k miles dies only when over 90+ outside but will restart immediately and drive for a mile or so then die again. It does have new fuel pump in last 10k miles but it's probably in need of basic tuneup plugs, wires...
Thanks for the comments guys.
Far left 85 c20 crew cab shortened frame, bagged no motor or trans currently
07 classic 1500 work truck
00 3500 454 belltech drop daily driver
86 k10 built 454 4" lift 35"s
86 c10 355 vortec heads, comp cam... formerly long bed
00 k2500 my plow truck
92 k1500...
I was walking down my driveway and noticed that most all of my trucks were at my house at the same time which rarely happens. Only thing missing is my wifes 99 tahoe we bought last year with 55k original miles. Dont hate the F100 too much haha, my grandfather bought it new, took me 17 years...
I'm having an issue with my upper ball joint bolts (nut side up) making contact with my spindles. Has anyone had this issue? Not sure what to do, I'd assume grinding material off the spindle is a no no. Any help would be great, thanks
Vehicle in question is '00 obs c3500 dually 6/8...
the mounting studs for the heater controls need to be cut off so the control can be relocated about 1/4" lower. I had to remove a lot of material from below and behind the radio to get everything to fit. Really not a big deal. I used a small air/body saw which was perfect.
sorry these pictures are really not good, I just couldnt get lighting right no matter where I moved the truck haha I got the gap around the radio pretty dialed in except the top has a slightly smaller gap than the bottom. I really wish I could have used the clips from the factory bezel because...
So I got the deck installed today. Not sure why but the deck isnt centered in the opening of the bezel but I was in a pretty big rush so I'll have to pull it out and see whats going again this weekend sometime and dye the bezel too. Overall the fitment is ok but not great. I'll try and post...
So I can't seem to find anyone running 285 75 17 on NBS wheels. I assume they should fit with a small crank, especially if they are undersized like my toyo 285 70s were. Anyone have pictures?