Recent content by cmeargle

answer to any 4l60e trouble

How about a slight tapping noise when at idle or in gear but only heard at lower rpms? No obvious shift problems or hesitation. Replaced flew plate a while back. Transmission came from a 98 surb. If that matters. Still a 4l60e. Truck is 96 sierra 5.7. Should I have made a necessary Modification...
- cmeargle
- Post #231
- Jan 22, 2017
- Forum: Transmissions
Truckin's diagrams

Hey would any one happen to have a diagram for the main fuse box under the hood? Ignition fuse B is giving me trouble. It keeps blowing any fuse I Put in there so I'm thinking there is an exposed wiring or some other wiring problem that is causing it to blow and keep my truck from cranking. Oh...
- cmeargle
- Post #15
- Jan 22, 2017
- Forum: Wiring Diagrams
Replaced fuel pump and still running poorly

Hooked up my buddies computer and throttle sensor popped up and a mifire. Gonna get a new sensor and put it back on the computer and go from there Sent from my VS880 using Tapatalk
- cmeargle
- Post #4
- Feb 21, 2016
- Forum: Street Chat / Timeslips
Replaced fuel pump and still running poorly

Check engine light has always been on. It does flash when the truck starts struggling so to say and raises to 2000rpm. Sent from my VS880 using Tapatalk
- cmeargle
- Post #3
- Feb 21, 2016
- Forum: Street Chat / Timeslips
Replaced fuel pump and still running poorly

Well guys I'm at a lost here. Replaced my fuel pump because my truck was acting as if it was going bad, so I replaced it. Now that I've replaced it the problems have only got WORST. I've replaced spark plugs and fuel filter as well. The truck fuel pressure is at 62. That shouldn't be my problem...
- cmeargle
- Thread
- Feb 21, 2016
- Replies: 3
- Forum: Street Chat / Timeslips
Salvage yard run

I may have the pigtails. I'm not sure, don't if I separated them or just dodnt grab them all. I'll check tomorrow and let you know. Sent from my VS880 using Tapatalk
- cmeargle
- Post #19
- Jan 1, 2016
- Forum: OEM and Custom Interiors
Salvage yard run

Don't if you've seen or not but That's both of them Sent from my VS880 using Tapatalk
- cmeargle
- Post #17
- Jan 1, 2016
- Forum: OEM and Custom Interiors
Salvage yard run

Works with me bud Sent from my VS880 using Tapatalk
- cmeargle
- Post #15
- Jan 1, 2016
- Forum: OEM and Custom Interiors
Salvage yard run

There very very small Sent from my VS880 using Tapatalk
- cmeargle
- Post #13
- Jan 1, 2016
- Forum: OEM and Custom Interiors
Salvage yard run

Not sure. I don't really need em so anything is fine with me Sent from my VS880 using Tapatalk
- cmeargle
- Post #11
- Jan 1, 2016
- Forum: OEM and Custom Interiors
Salvage yard run

Yeah there all for sale. I grab as many as I could cause I know some guys are always looking for them Sent from my VS880 using Tapatalk
- cmeargle
- Post #9
- Dec 31, 2015
- Forum: OEM and Custom Interiors
Salvage yard run

Still looking for one of these? Grabbed a few today Sent from my VS880 using Tapatalk
- cmeargle
- Post #7
- Dec 31, 2015
- Forum: OEM and Custom Interiors
replaced rear speakers

Yeah it was a bit much but wasn't too hard. Got a much needed cleaning out of it Sent from my VS880 using Tapatalk
- cmeargle
- Post #6
- Dec 26, 2015
- Forum: Audio + Electronics
replaced rear speakers

Got everything a little cleaner and wires tucked somewhat better. Gonna put the rear seat back in later today Sent from my VS880 using Tapatalk
- cmeargle
- Post #4
- Dec 26, 2015
- Forum: Audio + Electronics
replaced rear speakers

Sound awesome. Great quality. They cost me around 170 for all 4. There crossfire C5's. Sent from my VS880 using Tapatalk
- cmeargle
- Post #3
- Dec 26, 2015
- Forum: Audio + Electronics