Recent content by brandonb

  1. B

    454ss tranny problems?

    it wont shift up till a high speed without the modulator plugged in, or blown. is the fluid low, or burnt?
  2. B

    Pulling The Heads On 350 TBI

    i dont know which setup the 91 has. i think most of them had cast aluminum accessory brackets. check your drivers side, and if you see a bolt in the head that you cant get without removing the powersteering pump then you need to remove the powersteering pump.
  3. B

    Pulling The Heads On 350 TBI

    have you checked your valve lash? if a valve is incorrectly sat you wont get the right amount of air(thus reducing compression), and youll hear a tapping noise. remember to use 2 wrenches to remove the fuel fittings on the back of the throttleblody. the valve cover bolts are 3/8, the...
  4. B

    new gut from East TX

    im an hour north of you.
  5. B

    new gut from East TX

    this is the only pic i had on my computer.
  6. B

    new gut from East TX

    thanks for the welcome, ive looked around, and yall have a pretty good amount of information on here. maybee ill learn another trick or two for working on these old trucks.
  7. B

    700R4 to 4L60E swap

    alright, so i have a 92 C1500 silverado with a TBI 350 and a 700 R4. the trans has seen better days, so were going to replace it. i got a recently rebuilt 4L60E with the wiring harness and PCM from a 94 Cheyenne to put in the 92. the PO of the 94 put a new trans in it, then locked the motor...
  8. B

    new gut from East TX

    hey guys, im new to this forum. ive been working on GMT400s since I was little, mainly OBD1 trucks. dad has a 92 xcab C1500 Silverado that he bought used in '02 when it had 90,000 miles. weve kept it up as best we can, but its got a few scrapes. dads powertrane is a TBI 350/700R4/GU6 3.42...
Top