Recent content by BradHanks15
-
B
Slipping trans after rebuild.
Thanks. Is that the forward apply piston?- BradHanks15
- Post #73
- Forum: Transmissions
-
B
Slipping trans after rebuild.
@NickTransmissions got my replacement input drum in today and was going to assemble it and I found this. Just noticed it didn’t see it before. What kind of issues could this cause? And is there any way to replace just the seal or does the whole piston need to be replaced?- BradHanks15
- Post #71
- Forum: Transmissions
-
B
Slipping trans after rebuild.
@NickTransmissions. Cool. Definitely appreciate the help. Will definitely go ahead and get the input sprag and drum get those replaced and see how it goes. I’ll let you know when everything is back together. I’ll make sure to check line pressure first this time before taking it off the stands.- BradHanks15
- Post #70
- Forum: Transmissions
-
B
Slipping trans after rebuild.
@NickTransmissions I think I actually got my set up to work this time. Do these numbers look normal? This is on the pump.- BradHanks15
- Post #68
- Forum: Transmissions
-
B
Slipping trans after rebuild.
- BradHanks15
- Post #67
- Forum: Transmissions
-
B
Slipping trans after rebuild.
Sweet. Appreciate that. Gonna check the front pump one more time. If everything checks out you think I should replace the input drum? @NickTransmissions- BradHanks15
- Post #66
- Forum: Transmissions
-
B
Slipping trans after rebuild.
Also do you think if the forward accumulator check ball fell out of its spot it could cause that?- BradHanks15
- Post #65
- Forum: Transmissions
-
B
Slipping trans after rebuild.
@NickTransmissions took apart the input sprag and everything looked ok. I will do the things you suggested. Tested the afl valve it was about 17 and the tcc regulator was about 18.- BradHanks15
- Post #63
- Forum: Transmissions
-
B
Slipping trans after rebuild.
I tried it again in a different way and all the vacuum checks out again.- BradHanks15
- Post #62
- Forum: Transmissions
-
B
Slipping trans after rebuild.
@NickTransmissions I took apart the pump and cleaned everything. Recalibrated my setup and put in the sonnax valve. Now all my readings are super low. Could it be possible taking the pump part did this? And all the circuits quit like that enough though the truck drove great before the first...- BradHanks15
- Post #60
- Forum: Transmissions
-
B
Slipping trans after rebuild.
Ok. Thanks for the info. I’ll recalibrate it and try again. I’m gonna take the sprag apart today and investigate it.- BradHanks15
- Post #58
- Forum: Transmissions
-
B
Slipping trans after rebuild.
To be honest I can’t justify spending 350$ on that test station on something I’m gonna use once. So I’m using a different setup someone else did. I did the calibration process they used however. I’m still using the test plate though.- BradHanks15
- Post #56
- Forum: Transmissions
-
B
Slipping trans after rebuild.
My pump only goes up to 24 fully sealed btw.- BradHanks15
- Post #54
- Forum: Transmissions
-
B
Slipping trans after rebuild.
My set up shows 20 on the tcc. With the tester on the orfice and finger not in the valve bore it’s at 21 finger in the hole 22.5 and valve pushed has no change.- BradHanks15
- Post #52
- Forum: Transmissions
