BluC10
Newbie
What size light bar is that?
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Bumper looks good. Great fab skills. You do it the way I do, always make it way more heavy duty than it needs to be.In a step towards making the suburban into an overland trail rig, I found the time to improve my metal working skills and have some fun.
Inspired by this thread http://www.fullsizechevy.com/forum/...ations/482457-drisco-builds-bumper-again.html
This was the old set up
You must be registered for see images attach
PIcked a this 5” ¼in thickness box tube from a scrap yard for $80. This bumper is much stronger than the frame, hope to god I never have to put that to the test.
Fired up the plasma and got to chopping.
You must be registered for see images attach
You must be registered for see images attach
I used scraps of the box tube to make the mounts. It bolts directly to the frame. Used a mig welder.
You must be registered for see images attach
Mounted two 18,000 D rings and a front hitch receiver for winch and other fun possibilities. Then made two v notches and got it red hot with the torch (off the truck of course) to make some bends
You must be registered for see images attach
Next we added some lower panels out of 12 gauge sheet followed by lots and lots of grinding
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
Sand Blasted
You must be registered for see images attach
2 coats of primer, 2 coats of spray on bed liner. I decided that was way easier than powder coating and much easier to touch up should dings or modifications occur. Plus I think the finish looks really cool.
You must be registered for see images attach
Boom. We got a bumper
You must be registered for see images attach
Cranked the T bars just a bit to level it. Approach angle is wayyy better already. If you look at the shadow you can see the gap between bumper and body. Its not as bad as it looks.
You must be registered for see images attach
Made a mount for the licence plate into the hitch receiver and added a light bar.
You must be registered for see images attach
Later down the road I may add some more to the top for protection / catching deer, but for now i'm pretty happy with it. Backing trailers with a front hitch is fun.
Pictures or if didn't happena bumper like that would look good on my one ton. just finished the rear bumper, all made from scrap and want to do the same on the front.
here it is unfinished, parked on the railroad tracks:Pictures or if didn't happen