Anything exhaust - from headers cats and pipes to tips.
any1 got pics of their exhaust setup ? my 89 swb has duals but does a 90 degree at the gas tank and crosses under drive shaft. i really don't like it...
Hey everyone. I just bought a 1988 GMC C1500. I want some good sounding exhaust but not something to loud. Any ideas or suggestions?
Looking for a dual exhaust kit for a 98 tahoe 2dr 4wd anybody????
I saw a crack in my passenger side exhaust manifold today. Hopefully this is my running rich and bad MPG problem. Does anyone know if the Dorman...
Ok, so I screwed up ordering my headers. They dont have an egr port. So i either need to fab one into my headers (no thanks) or have the egr...
Currently i have the stock dual inlet/single outlet exhaust on my ECSB (5.7 vortec) A friend of mine is selling a custom exhaust from his RCSB......
I'm looking at doing a set of headers, cats, x pipe, and mufflers. I'm not sure if it matters (read it did somewhere and figured Id ask) the order...
as it says,,toke me long enough very loud,much louder than they were on my previous truck but i love em
looking at headers whats better ceramic coated or stainless anyone know where to get a good deal on either for a 96 5.7 sfi also, im looking...
everytime a look at headers on summit they only show shortys and a couple full length but would long tube headers be hard to put on this model since...
well am desiding h or x pipe or none,which one wounld yall chose.I am going to run 3 inch dual pipe form headers back with super 44s or chery bomb...
Finally getting round to knocking up some tips for my exhaust. Was going to buy a pair of Gibson tips.....but decided, seeing as I fabbed the entire...
I figure I'd start a thread for magnaflow exhausts, including videos/pictures/info, that can be used for reference to anyone that has interest or...
I have been looking for a deep tone muffler that will peirce your ears,i have looked on youtube about the cb extremes and flow 10s is there any realy...
Advance Auto has two different ones listed. One is 2 1/2 inch OD and one is 2 3/32 inch OD.
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules