Astro's latest activity
-
Astro replied to the thread Stalling/Hesitation When cold.Hey man, did you ever figure out what caused your issue? I've been having something similar happen to my 96. It hesitates when I give it... -
Astro replied to the thread Top end build worth it?.I would change the lifters if they've got high mileage on them since you're opening her up. I believe the springs are really dependent...
-
Astro replied to the thread Best cold air intake?.The closed box design is what really sold me man. The stock setup is actually a good one. Just the tubing and filter could be improved...
-
I’m tempted to get one for my TBI. Can’t decide.
-
Astro replied to the thread Running a heavier oil.My engine seems to be happy with rotella t6 15w40. Been running it a while with no issues.
-
Spinning with axles out creates more "spidey work". @Pinger said there are two pin choices. Aftermarket is not the problem if you were...
-
Astro replied to the thread Welp I screwed something up..I didn't have two choices from where I purchased and I didn't know that was the case. I bought it from Yukon and that was the ONLY one...
-
Astro replied to the thread Welp I screwed something up..Hey guys, sorry for the late reply. It turned out to be the pin. It was way too long. I'm almost wondering if the hole for the retaining...
-
And silly question as I'm sure you've seen the discussion here about it - what speciically did you refill it with? Richard
-
Yes, any spinning while axles are out can move spiders and the spacers/washers under them. Is there an additive needed? Is the seal...
-
Did one of the spider gear washers get missed? as in not back under the spider gear?
-
Crosspin slightly too long (there are two listed for G80s if that's what you have) and fouling the pinion?
-
Astro replied to the thread Best cold air intake?.Well, I have the volant 15957 on order. Hopefully it fits right. Not sure why, but then picture on Amazon shows a different year...
-
All I have run for nearly 2 decades is an oil'd filter. Work great for me.
-
A few words about oil'd filters. My dad had a shop for 25yrs, and we sure saw our fair share of sensor failures due to k&n oil in the...
Latest posts
-
-
-
-
12200411 PCM swap for 1996 to 2000 GMT400 trucks
- Latest: Motorsports-X
-
Staff online
-
df2x44L60E Destroyer